NTI ENVIROMUX Series User Manual

NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
23
Remote RS232 Device Control
The “RS232 AUX” port can be used to connect a remote serially-controlled device (E-5D and -16D only). Once connected, a
user named “rs232” can login to the ENVIROMUX from a command prompt and begin sending commands directly to the serial
device.
Figure 24- Connect serially controlled device
To control a remote serially-controlled device from the “RS232 AUX” port:
1. Configure the “Auxiliary Serial Port” under System Configuration (page 68) as a Remote Serial Port with the correct
parameters for communication with the device.
2. Setup a user named “rs232” (must be lowercase letters) with password under User Configuration (page 82)
Figure 25- Create user "rs232"

NTI ENVIROMUX Series Specifications

General

Product Type	Environmental Monitoring System
Temperature Range	-40°C to 85°C
Power Supply	12V DC or 24V AC
Network Interface	Ethernet 10/100 Mbps
Alarm Notifications	Email, SNMP
Sensor Types Supported	Temperature, Humidity, Water, Airflow
Power	12V DC or 24V AC
Operating Temperature	-40°C to 85°C
Mounting	Wall or Rack Mount
Communication Interfaces	Ethernet
Data Logging	Yes
Compliance	CE, RoHS