NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
109
Figure 122- Smart Alert Configuration- continued
Remote SSH Commands
Remote address Enter the IP address or host name of the Linux or Unix computer to be sent a command via an SSH
connection.
Enable command on event
triggered
Place a checkmark here to send a command when this Smart Alert is triggered
Command on triggered Enter an SSH command to be sent to the remote address when this Smart Alert is triggered
(examples of commands include “poweroff” and “reboot”)
Enable command on event
cleared
Place a checkmark in this box to send a command when this Smart Alert returns to normal
Command on cleared Enter an SSH command to be sent to the remote address when this Smart Alert returns to normal
After all options are selected, click the “Save” button. This Event will now be added to the Events page (Figure 114). Up to 50
events can be
defined. Events can be configured to trigger alerts by themselves, and/or be used in combination with other
events to trigger Smart Alerts.
The Unix or Linux machine to receive the commands must be configured to receive them before these commands will work. See
“More on SSH Commands” on page 105 for instruction to setup the Unix or Linux machine.
To Next Page
Loading...
Need help?
General
