NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
74
Administration-Network Setup
From the Network Configuration page
(Administration->Network) the administrator
can either choose to have the IP address and
DNS information filled in automatically by the
DHCP server (the default setting), or manually fill
in the fields (use a static address). Settings can
be entered for either the IPv4 or IPv6 protocols.
Note: If you select “DHCP”, make sure a
DHCP server is running on the network the
E-16D is connected to.
Figure 83- Network Configuration Page
Settings can be entered for either
the IPv4 or IPv6 protocols.
Figure 84- Apply IPv4 or IPv6 Settings
If the administrator chooses to have the DNS information filled in automatically, the SMTP server and port number still need to be
entered for e-mail alerts to work. If the SMTP server requires a password in order for users to send e-mails, the network
administrator must first assign a user name and password to the ENVIROMUX. Then apply the user name and password to the
"User" and "Password" fields under “SMTP Settings”. The ENVIROMUX must be power-cycled for changes to the SMTP server
to take effect. Once all users are configured, click the "Send Test Email to all Users" button to check that all settings have
been done properly. This will send an email to all users configured in the user list.
For additional detailed information on setting up email, see "How to Setup Email
".
If the DNS server is slow to
respond, increase this value
to up to 30 seconds
To Next Page
Loading...
Need help?
General
