NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
60
Data Logging
Add to data log This is a check-box that lets the user decide if the data sampled should be recorded in the Data
Log.
Logging Period Enter the time period between logged measurements
IP Sensors
Sensors connected to an E-MICRO-T(RHP) or E-1W can be monitored and configured from the E-xD interface.
On the IP Sensors page, click on “Add New IP Sensor”. On the page that opens, enter a description to be viewed on the sensor
summary page for this group of sensors, enter the IP Address of the E-MICRO or E-1W to be monitored, and select the Sensor
Type between E-MICRO "MICRO" or E-1W "E1W". Up to 8 different E-MICRO and up to 4 different E-1W IP Addresses can be
added. When finished, click on “Add”.
Figure 62- Add IP Sensor
The E-xD will then sense what sensors are attached to the E-MICRO and E-1W units and add them to your summary list under
“IP Sensors”. Once listed, to view the status of an individual sensor, click on “View”. To change the configuration, click on “Edit”.
Figure 63- IP Sensor List
In a cascaded configuration of E-xD units, IP sensors (maximum of 12) must be configured from the Master unit to receive alerts
about those sensors.
Note: The configuration settings applied to these sensors in this interface will not alter the settings as configured within
the E-MICRO web interface.
Note: When using an E-MICRO as an
IP sensor for an E-xD, be sure to set
the E-MICRO "Web Server Type" to
HTTP under Network Settings (in the
E-MICRO web interface).
To Next Page
Loading...
Need help?
General
