45762101TH Rev.1
3-24
Display Setting value
Operation at the
setting value
Function
TONER SENSOR ENABLE Detects Valid/Invalid of toner sensor
operation.
DISABLE Not to detect
ID UNIT CHECK ENABLE Checks Valid/Invalid of ID installation
check operation.
DISABLE Not to check
DRUM OVER LIFE STOP Not to continue The restriction on extending
the life of toner-related items
five times is lifted.
CONTINUANCE To continue
WR POINT REV
TBL=**H±*.***mm
00H~FFH Correction
value
The correction value is added
to the existing write-down
position.
BOTTOM WRT POINT
TBL=**H±*.***mm
00H~FFH Cut value Amount of cut at the rear end
of a paper is set.
Hatched portion: Default is shown
3.4.2.10 LED head serial number display
This self-diagnostic menu item is used to check whether the downloaded LED head data
matches the serial number of the actual LED head.
1. Enter the self-diagnostic mode (level 1), press the [2]
or
[8] key repeatedly ,and
press the [6] key when the "LED HEAD DATA" is displayed in the upper row of the
display area. (Pressing the [2] key increments the test item and pressing the [8] key
decrements the test item.)
2. When the [2] key or the [8] key is pressed, serial numbers of the K LED head data
are displayed in order.
3. Pressing the [4] key terminates the test. (Returns to the status of step 1.)
K ** ** ****
xxxxxxxxxxxxx
** ** **** : Rev number
xxxxxxxxxxxxx : serial number
3.4.2.11 NVRAM parameter setting
Do not use this menu item.
To Next Page
Loading...
Need help?
General
