45762101TH Rev.1
4-70
2) Motor-Assy / Gear-Idle / Gear-Pulley(E2M)
Detail Fig-2
45439901PP Gear-Pulley(E2M)
44522701PP Gear-Idle
44522701PP Gear-Idle
Overflow is possible
Apply to 1 place. (The application place is arbitrary)
It is application to a state without a lump jumping
out of an Gear tooth top, the tooth bottom.
EM-30LP Class C x2
It is application to each gear with MOLYKOTE
(EM-30PL) regular on the gear tooth surface
Flange convex grease application
point Grease lump possibility
(All laps)
EM-30LP Class C
MOLYKOTE (EM-30LP) to a side flange ( )
side in a gear tooth side.
Apply all regular laps (All laps)
44596402PA Motor-Assy
Motor Gear
⑨
Guide-Assy-Top-B
⑩
Guide-Assy-A
SF-133 Class C
Apply a normal amount of HANARL
(SF-133) to the hatching area.
(All circumference of shaft)
Shaft can be soaked in HANARL.
Leave it for about 3minutes (drying time) after painting HANARL SF-133, and then
assemble the roller.
SF-133 Class C
Apply a normal amount of HANARL
(SF-133) to the hatching area.
(All circumference of shaft)
Shaft can be soaked in HANARL.
Leave it for about 3minutes (drying time) after painting HANARL SF-133, and then
assemble the roller.
To Next Page
Loading...
