Oki Data CONFIDENTIAL
2. TROUBLESHOOTING PROCEDURES
45762101TH Rev.1
2-3
2.5 Troubleshooting method
If a trouble occurs in the printer, search for it by the following procedure:
Problem
generated
Problem is displayed
in LCD.
Repair using the
"LCD message list"
(see 2.5.1 to 2.5.3).
Repair in detail using
troubleshooting flow
(see 2.5.5).
Abnormal image (or
problems that are
not displayed in the
LCD)
Repair in detail using
troubleshooting flow
(see 2.5.6 to 2.5.8).
Initializing & Shutdown
No. Category
PJL
Status
Code
Error Warning Description
1 Initializing - 1
2
3
4
5
Menu Resetting Indicates that EEPROM of the
controller side is being reset.
The condition that EEPROM is
reset includes the followings.
- Changes of destination
channel
- Compulsive initialization of
EEPROM
- Reset by a FactoryDefaults
operator of PS
- OEM set of PJL command
2 Initializing - 1
2
3
4
5
Wait a moment.
Network initializing ...
The network is in initializing.
If this status occurred during
the unit initialinzing the
message is displayed by
English.
3 Initializing - 1
2
3
4
5
Flash Memory Format Displays that Flash memory is
being formatted.
It is displayed it when "Service
Menu"-"System Maintenance"-
"Format Flash Memory" of a
system maintenance menu is
performed.
The function mentioned above
is secret to users. Therefore,
this status does not occur in a
user environment.
4 Initializing - 1
2
3
4
5
Erasing Disk
%PERCENT%
Indicates that the Flash
memory is being erased.
Erase process of the Flash
memory is valid to start from
"Management"-"Flash Memory
Setup"-"Initialize" of Admin
Setup Menu.
%PERSENT% : A ratio of the
capacity that elimination was
finished.
2.5.1 LCD messages list