Oki MB472w - Guide Eject Lower Assy

45762101TH Rev.1
4-41
Oki Data CONFIDENTIAL
4.REPLACEMENT OF PARTS
4.2.21 Guide Eject Lower Assy
(1) Remove the Scanner unit. (Refer to 4.2.8)
(2) Remove the Cover Assy Rear. (Refer to 4.2.20)
(3) Remove the Cover-Eject. (Refer to 4.2.16)
(4) Remove two screws (Silver : 8mm)
①
. Remove the Cover-Cassette-Rear
Assy
②
and Guide-Eject-Lower-Assy
③
.
(5) Remove the post
④
. Remove the Separator-SB-FD
⑤
and Spring-
Separator_SB
⑥
.
(6) Remove the Lever-Exit-Sensor
⑦
and Spring-Sensor-Exit
⑧
.
(7) Remove the Exit-Sensor
⑨
.
(8) Installing is performed by the inverse procedure with removing.
Note!
1. Beware of not to touch the DC motor inattentively (Do not rotate motor).
2. Install Cover-Cassette-Rear Assy
②
carefully to avoid the FFC cable
from being caught.
A
A
①
①
②
③
④
⑤
⑦
⑧
⑨
⑥
FFC cable