Oki MB472w - 5.5 Cleaning Rollers in the ADF

Oki Data CONFIDENTIAL
5. REGULAR MAINTENANCE
45762101TH Rev.1
5-8
5.5 Cleaning Rollers in the ADF
If the document feeding rollers in the ADF are contaminated with ink, toner particles
or paper dust, documents and outputs get dirty and a paper jam may occur. To
prevent this, it is recommended to clean the rollers once a month.
( 1 ) P o w e r o f f t h e M F P.
(3) Wipe the document feed roller, guide surface, rubber pad, and rubber sheet
with a soft cloth that has been slightly moistened with water and squeezed
well. Wipe the whole surface of the roller while turning it with your hand.
Note! If the rollers get too dirty, wipe them with a soft cloth lightly moistened
with neutral detergent, and then wipe it again with a soft cloth lightly
moistened with water.
(2) Open the ADF cover.
Document feed roller
Rubber Pad
guide surf
ace
Rubber Shee
t
(4) Close the ADF Cover.