Oki MB472w - Page 178

45762101TH Rev.1
4-58
Oki Data CONFIDENTIAL
4.REPLACEMENT OF PARTS
Detail
⑧
-1 Frame-Assy-TR
Note1) Please wipe the amount that grease began to see the sliding area off.
Gear-Exit (Z19)
Bearing-Eject_R
See Note 1)
See Note 1)
Bearing-Feeder
See Note 1)
EM-30LP Class C
Apply a normal amount of MOLYKOTE
(EM-30LP) to bearing surface of the shaft.
EM-30LP Class C
Apply a normal amount of
MOLYKOTE (EM-30LP) to bearing
surface of the shaft.
EM-30LP Class C
Apply a normal amount of MOLYKOTE
(EM-30LP) to flange surface.
Roller-Pinch
Shaft-Idle-Dup
EM-30LP Class A
Apply a normal amount of
MOLYKOTE (EM-30LP) to the
hatched areas.
(Side of roller and ditch of
shaft)
(The other side is also the
same. : Four places in total)
Frame-Guide-TR
Roller-Pinch
Shaft-Idle-Dup
Note:1
EM-30LP Class B
Apply a normal amount of
MOLYKOTE (EM-30LP) to the
hatched areas.
(Center of shaft)
Note:1
Note:1
Note:1
Note:1