Oki MB472w - Page 185

45762101TH Rev.1
4-65
Oki Data CONFIDENTIAL
4.REPLACEMENT OF PARTS
Portion B, C, D and E For detail
Frame-ADF
EM-30LP Class C
Apply a normal amount of
MOLYKOTE (EM-30LP) to the
hatched area.
(all circumference of post)
SF-133 Class C
Apply a normal amount of HANARL
(SF-133) to the hatched area.
(all circumference of post)
Post can be soaked in HANARL
SF-133 Class C
Apply a normal amount of HANARL (SF-133) to the
hatched area.
(all circumference of the sliding surfaces)
Leave it for about 3minutes (drying time ) after painting HANARL SF-133,
and then assemble the ADF-Assy.
Gear-Double-Z26-42
Gear-Planet
Gear-Drivet_Z44
Gear-TL-Sep_Z43-55
Gear-Double-Z31_44
Gear-Double-Z27-55
EM-30LP Class
E
Apply a normal amount
of MOLYKOTE
(EM-30LP) to the hatched area.
(all circumference
)
Gear-Planet_Z19
Gear-Clutch
Apply to 1 place with range 10mm or more. (The applica-
tion place is arbitrary) It is application to a state without a
lump jumping out of an Gear tooth top, the tooth bottom.
EM-30LP Class D x1
Apply a normal amount of MOLYKOTE (EM-30LP) to the
hatched area. (to 1 places on the gear tooth circle)
(Refer to detail)
EM-30LP Class C
Apply a normal amount of MOLYKOTE
(EM-30LP) to the hatched area.
(all circumference )
10mm or more