2-14 Service Manual
250.xx Paper Jam
Check Manual
Feeder
A single page of media is jammed in
the multipurpose feeder.
Open tray 2 to access the jam area.
Remove the jammed page. See “250
paper jam” on page 3-43.
250.xx Paper Jam
<x> Pages Jammed
Multiple pages of media are jammed in
the multipurpose feeder.
Open tray 2 to access the jam area.
Remove all the jammed pages. See “250
paper jam” on page 3-43.
271.22 Paper Jam
Check <area>
or
271.22 Paper Jam
<x> Pages Jammed
Output bin 1 declared jam.
290.02 Scanner ADF
Feed Jam
The scanner ADF has failed to feed a
page to the ADF interval sensor.
Remove the sheet of paper rom the ADF.
Retry the job. If the error recurs, Go to
“ADF paper jam service check” on
page 2-68.
290.10 Scanner
Static Jam
Scanner ADF detects paper at the first
scanner sensor while the ADF is in an
idle state.
Remove all paper from the ADF. Retry the
job. If the error recurs, Go to “ADF paper
jam service check” on page 2-68.
290.20 Scanner
Static Jam-Paper
Present
This message occurs when paper is
detected in the ADF during a POR, or
when the MFP is starting up.
Remove original documents from the ADF.
290.30-Scanner
Static Jam-Paper
Stop
This message displays when paper is
inserted past the paper stop on the
ADF.
Remove original documents from the ADF.
291.00 Scanner Jam,
remove all originals
from the scanner
Scanner ADF detects paper at the
second scanner sensor while the ADF
is in an idle state.
291.01 Scanner Jam,
remove all originals
from the scanner
This message is posted if a jam is
detected at the first scanner sensor.
292 Scanner jam,
remove all originals
from the scanner
This message appears if the ADF
cover is open while paper is fed
through the ADF.
Remove the paper from the ADF, and
close the ADF cover. If the error recurs, Go
to “ADF cover open service check” on
page 2-67.
293 Replace all
originals if restarting
job
No paper sensed in the ADF. Ensure that the paper present actuator is
in the correct position. See
“ADF paper
jam service check” on page 2-68.
293.02 Flatbed cover
open
The MFP senses that the flatbed cover
is open.
Close the flatbed cover. See “ADF cover
open service check” on page 2-67.
294.04 Scanner jam,
remove all originals
from the scanner
Jam at the ADF exit sensor. Remove all paper from the ADF. If the
error recurs, “ADF paper jam service
check” on page 2-68.
294.05 Scanner jam,
remove all originals
from the scanner
A jam is detected at the ADF exit
sensor.
Paper jam messages (2xx) (continued)
Error code Description Action
Y112730-2
To Next Page
Loading...
Need help?
General
