Olivetti d-Color MF920 Service Manual

Diagnostic information 2-29
882 Failure to transmit training successfully
in V17, V29 terminal modulation
schemes.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
883 Failure to transmit training successfully
in V17,V27 terminal modulation
schemes.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
884 Failure to transmit training successfully
in V29, V27 terminal modulation
schemes.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
885 Failure to transmit training successfully
in V17terminal modulation scheme.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
886 Failure to transmit training successfully
in V29 terminal modulation scheme.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
887 Failure to transmit training successfully
in V27 terminal modulation scheme.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
888 Failure to transmit training successfully
at 2400 bps in V27 terminal modulation
scheme.
• Adjust “Transmit Level”.
• Check line quality.
889 Failed to connect at the minimum
speed supported by the MFP.
• Adjust “Transmit Level”.
• Incompatible connection.
88A Failed to connect using V.34
modulation scheme.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive
Threshold values.
901 No fax tones detected from remote
end.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
902 No dial tone detected. • Check by enabling ‘Behind a PABX’
setting.
• Check phone line.
• Check MFD modem hardware.
903 Busy tone detected. Check with remote end if successive
attempts fail.
904 Hardware error detected. See “Modem / fax card service check”
on page 2-71.
905 A timeout occurred after dialing the
number and waiting for a response.
Check with remote end if successive
attempts fail.
906 Fax cancelled by user. No action needed.
Fax error log codes (continued)
Error code Description Action
Y112730-2

Olivetti d-Color MF920 Specifications

General

Brand	Olivetti
Model	d-Color MF920
Category	All in One Printer
Language	English