Omron CQM1H - 08-2005 - Page 173

148
Connecting the Programming Console Section 7-2
C200H-PRO27-E Key Sheet
Different Keys The following keys are labeled differently on the CQM1H-PRO01-E, CQM1-
PRO01-E and the C200H-PRO27-E, but the operation of the keys in each pair
is identical.
Note To specify the AR area, use SHIFT + HR Keys for the C200H-PRO27-E and
use SHIFT + AR/HR Keys for the CQM1H-PRO01-E or CQM1-PRO01-E.
Using Programming
Console Keys
Programming Console keys are used either individually or in combination with
the SHIFT Key. The normal and SHIFT Key input of each key is written on the
key.
Normal Input
The normal input for the key is written in the middle or at the bottom of the key.
SHIFT Key Input
The input for the key after the SHIFT Key has been pressed is written at the
top of the key or in the upper left corner of the key. It is not necessary to keep
the SHIFT Key pressed down when pressing the next key.
A shift symbol will be displayed in the upper right corner of the display when
the SHIFT Key is pressed. The shift input can be cleared by pressing the
SHIFT Key again.
The operating mode can be changed without changing the display by pressing
the SHIFT Key first.
SHIFTFUN
AND
LD
SFT NOT
OR
OUT
CNT
TIM
TR
*EM
LR
CH
*DM
HR
CONT
*
CLR
EM
DM
PLAY
EXT
SET
REC
RESET
VER
CHG SRCH
DEL
INS
WRITE
MONTR
Use the SHIFT + HR
Keys to specify the
AR area.
CQM1-PRO01-E Keys C200H-PRO27-E Keys
AR
HR
LR
AR
HR
HR
SET
PLAY
SET
RESET
REC
RESET
Normal input
Input with SHIFT Key
FUN
HR
AR
0
A
Input with SHIFT Key
Normal input
Normal input
Shift input
symbol
^
SHIFT