Unlock the Robot 2-32
Unlock the Knob-type Robot Lock 2-33
Unlock the Thumbscrew-type Robot Lock 2-33
Apply Power to the Library 2-34
Configure the Library After Powering-on for the First Time 2-34
Configure the Library: Login with the Default Admin 2-35
Configure the Library Step 1 of 6: Change the Default Administrator Password 2-35
Configure the Library Step 2 of 6: Configure the Network Port 1 2-36
Configure the Library Step 3 of 6: Set the Library Date and Time 2-37
Configure the Library Step 4 of 6: Set the Drive Element Addressing Mode 2-37
Configure the Library Step 5 of 6: Configure the Mailslot, Reserved Slots and
Volume Label Format 2-38
Configure the Library Step 6 of 6: Review and Apply Initialization Settings 2-39
Configure the Library: Finish the New Configuration 2-40
Run a Self-Test 2-40
Stopping a Self-test 2-41
3
Basic User Interface Operations
Log In to the Remote Interface 3-1
Log Out of the Remote Interface 3-1
Show, Hide, and Reorder Table Columns 3-1
Export a Table as a Spreadsheet 3-2
Print a Table 3-2
4
Configure the Library
Run the Configuration Wizard 4-1
Configure the Network Interfaces 4-2
Verify Job Activity and Launch the Wizard 4-2
Configure Network Port 1 4-2
Configure Network Port 2 4-3
Set the Library Date and Time 4-4
Configure Library Settings 4-4
Partition the Library 4-5
Access the Partitioning Screen 4-6
Create a New Partition 4-6
Assign Resources to the Partition 4-7
Delete an Existing Partition 4-7
Configure Library Managed Encryption (LME) 4-8
Obtain Information from OKM 4-8
Configure the SL150 to Manage Encryption 4-8
v
To Next Page
Loading...
