Clean the Tape Cartridge Exterior 6-8
Store Tape Cartridges 6-8
Load the Magazines (Bulk Loading) 6-9
Unlock and Remove the Magazines 6-9
Load the Left Magazine in the Base Module 6-9
Load the Remaining Magazines 6-11
Lock the Magazines and Audit the Library 6-11
Update Media Health After a Bulk Load 6-11
Import or Export Cartridges Using the Mailslot 6-12
Assign the Mailslot to a Partition 6-12
Import Tape Cartridges 6-13
Export Tape Cartridges 6-13
Open the Mailslot 6-13
Close the Mailslot 6-14
Unassign the Mailslot 6-14
Move Tape Cartridges with the Remote Interface 6-15
Determine the Required Number of Reserved System Slots 6-15
Determine the Number of Cleaning Cartridges 6-16
Manage Expired Cleaning Cartridges 6-16
Monitor Cleaning Cartridges Using the Remote Interface 6-17
Replace Expired Cleaning Tapes Using the Remote Interface 6-17
Replace Expired Cleaning Tape Using the Host Application 6-18
Media Validation 6-18
Add a Drive to the Media Validation Pool 6-19
Remove a Drive from the Media Validation Pool 6-19
Start a Media Validation 6-20
Manually Cancel a Validation in Progress 6-20
Media Validation Type 6-21
Effects of a Library Restart on Media Validation 6-21
Why Aren't the Media Validation Drives Showing in STA? 6-21
7
Tape Drives
Supported Tape Drives 7-1
Bridged Tape Drives 7-2
Library Managed Encryption (LME) 7-2
Behavior of Library Port 1 and Port 2 with LME 7-3
View Drive Information 7-4
Configure Drive Cleaning 7-4
Enable Library-Managed Drive Auto Cleaning 7-5
Configure Host-Managed Drive Cleaning 7-5
vii
To Next Page
Loading...
