Oracle SPARC T5-4 - Page 142

Install a Power Supply
142 SPARC T5-4 Server Service Manual • July 2016
3.
Press the lever against the power supply to fully seat the power supply in the
server.
4.
Insert the power cord into the AC connector for the power supply that you just
installed.
As soon as power is applied to the server, standby power initializes the service processor.
Depending on the server's OpenBoot PROM settings, the host server might automatically boot,
or you might need to boot it manually.
5.
Verify the power supply.
See “Verify a Power Supply” on page 143.
Related Information
■
“Power Supply and AC Power Connectors” on page 135
■
“Power Supply and AC Power Connector LEDs” on page 137
■
“Determine Which Power Supply Is Faulty” on page 138
■
“Remove a Power Supply” on page 138
■
“Verify a Power Supply” on page 143