Remove the Rear Chassis Subassembly
Servicing the Rear Chassis Subassembly 185
2.
Power off the server.
See “Removing Power From the Server” on page 51.
3.
Disconnect the power cords.
See “Disconnect Power Cords” on page 53
4.
From the front of the server, remove the following components:
■
Both processor modules – see “Remove a Processor Module or Processor Filler
Module” on page 61.
■
Main module – see “Remove the Main Module” on page 99.
■
Both power supplies – see “Remove a Power Supply” on page 138.
5.
Go to the rear of the server and remove the following components:
■
All five fan modules – see “Remove a Fan Module” on page 147.
■
All PCIe carriers or PCIe filler panels – see “Remove a PCIe Card Carrier” on page 158.
Make note of the slots for each carrier or filler panel so that you can install them into the
same slots.
■
Rear I/O module – see “Remove the Rear I/O Module” on page 176.
You will install these components into the replacement rear chassis subassembly once you have
replaced the faulty subassembly.
To Next Page
Loading...
Need help?
General