Panasonic DLP PT-RZ34K

Chapter 5 Operations — Using the information monitor function
264 - ENGLISH
7) Press qw to switch the setting item.
f The items will switch each time you press the button.
[USER VIEW]
Sets the screen mode during no operation to the USER VIEW mode.
Displays the items set in the menu operation mode → [SETUP] menu → [INFO MONITOR]. For
details, refer to “Setting the information to display” (x page 264).
[OFF]
Sets the screen mode during no operation to the hide mode.
Does not display the information.
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [PROJECTOR SETUP] menu → [INFO MONITOR SETTING] → [DEFAULT]
f Even if [DEFAULT] is set to [OFF], the content of an error or a warning is automatically displayed when it occurs.
r Setting the information to display
Set the items to display during the USER VIEW mode.
1) Press as to select [SETUP].
2) Press the <ENTER> button.
f The sub-menu item is displayed.
3) Press as to select [INFO MONITOR].
4) Press the <ENTER> button.
f The detailed setting item is displayed.
5) Press as to select an item to change setting.
f The current setting is displayed.
Item Details Factory default
[INPUT] Currently selected input terminal
*1
[ON]
[SIGNAL NAME] Input signal name [ON]
[AC VOLTAGE] Input supply voltage [ON]
[INTAKE AIR TEMP.] Intake air temperature of the projector [ON]
[EXHAUST AIR TEMP.] Exhaust air temperature of the projector [OFF]
[SHUTTER]
Status of the shutter ([CLOSE]: Shutter function enabled; [OPEN]: Shutter
function disabled)
[OFF]
[OSD] Status of the on-screen display function ([ON]: Display; [OFF]: Hide) [OFF]
[IP ADDRESS(WIRED)] IP address of the wired LAN [OFF]
*1 The representative input terminal is displayed when one image is displayed with multiple input signals.
6) Press the <ENTER> button.
f Setting can be changed.
7) Press qw to switch the setting.
f The items will switch each time you press the button.
[ON] Displays the items during the USER VIEW mode.
[OFF] Does not display the items during the USER VIEW mode.
f Repeat Steps 5) to 7) until the desired display items are set.
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [PROJECTOR SETUP] menu → [INFO MONITOR SETTING] → [USER VIEW]
r Setting the direction to display
Set the direction of the text to display in the information monitor.
1) Press as to select [SETUP].
2) Press the <ENTER> button.
f The sub-menu item is displayed.