Panasonic DLP PT-RZ34K

Chapter 5 Operations — Using the information monitor function
266 - ENGLISH
4) Press the <ENTER> button.
f The network selection item is displayed.
5) Press as to select [WIRED LAN].
6) Press the <ENTER> button.
f The detailed setting item is displayed.
7) Press as to select [DHCP].
f The current setting is displayed.
8) Press the <ENTER> button.
f Setting can be changed.
9) Press qw to switch the setting item.
f The items will switch each time you press the button.
[ON]
Acquires the IP address automatically if a DHCP server exists in the network where the projector is to
be connected.
[OFF]
Set [IP ADDRESS], [SUBNET MASK], and [DEFAULT GATEWAY] if a DHCP server does not exist in
the network where the projector is to be connected.
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [NETWORK] menu → [WIRED LAN] → [DHCP]
r Specifying the wired LAN IP address
Set the IP address, the subnet mask, and the default gateway if a DHCP is not used.
1) Press as to select [SETUP].
2) Press the <ENTER> button.
f The sub-menu item is displayed.
3) Press as to select [NETWORK].
4) Press the <ENTER> button.
f The network selection item is displayed.
5) Press as to select [WIRED LAN].
6) Press the <ENTER> button.
f The detailed setting item is displayed.
7) Press as to select [IP ADDRESS], [SUBNET MASK], or [DEFAULT GATEWAY].
f The current setting is displayed.
8) Press the <ENTER> button.
f Setting can be changed.
9) Press asqw to enter the address.
f Press qw to select the number to change, and press as to change the number.
10) Press the <ENTER> button.
f The setting is reected.
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [NETWORK] menu → [WIRED LAN] → [IP ADDRESS]/[SUBNET MASK]/[DEFAULT GATEWAY]
f The number can be entered with the number (<0> - <9>) buttons on the remote control when the projector is in the standby status.