Chapter 2 Getting Started — Connecting
62 - ENGLISH
When [SDI MODE] is set to [OUTPUT]: 50 m (164'1") (When L-5.5CUHD is used, the cable length should be 90 m (295'3").)
f When the [DISPLAY OPTION] menu → [SLOT IN] → [SDI MODE] is set to [OUTPUT], attach a terminating resistor (75 Ω) to the terminal
with no device connected as an output destination.
f Use the BNC connector that is compatible with the coaxial cable and type of the signal to be used.
f Setting the [DISPLAY OPTION] menu → [SLOT IN] is required depending on the connected external device or the input signal.
f Setting the [DISPLAY OPTION] menu → [SLOT IN] → [SDI LINK] is required when the dual link signal is input.
f To input the dual link signal, use the cable with same length and same type for connecting to the <SDI 1 IN> terminal and the <SDI 3 IN>
terminal. The image may not be projected correctly when the difference of the cable length is 4 m (13'1") or more.
f Directly connect the projector with the external device that will output the signal without going through a distributor, etc., when inputting dual
link signals. A phase difference is generated between the Link A signal and the Link B signal, and the image may not be projected correctly.
f An error in signal detection may occur when an unsteady signal is input to the projector. In such case, set the [DISPLAY OPTION] menu →
[SLOT IN] to the content corresponding to the input signal.
f The <SDI 2 IN/1 OUT> terminal and the <SDI 4 IN/3 OUT> terminal do not support the input of the 6G-SDI signal or the 12G-SDI signal.
f To use the <SDI 2 IN/1 OUT> terminal or the <SDI 4 IN/3 OUT> terminal as an output terminal, set the [DISPLAY OPTION] menu → [SLOT
IN] → [SDI MODE] to [OUTPUT].
For <SDI OPT 1 IN>/<SDI OPT 2 IN> terminals of the Interface Board
This is an example when the optional Interface Board for 12G-SDI Optical (Model No.: ET-MDNFB10) is installed
in <SLOT>.
HD-SDI signal, 3G-SDI signal, 6G-SDI signal, or 12G-SDI signal
SDI - optical converter
Optical fiber cable
12G-SDI signal output compatible device
Note
f Prepare the commercially available SFP module and the optical ber cable required for connection according to the usage, video signal to
be input, specication of the external device to be connected, etc.
f The transmission distance may become shorter and the image may not display correctly when there is dust on the connector of the SFP
module or optical ber cable, or it is dirty. Attach the protection cap or cover supplied by each product to the connector of the SFP module or
the optical ber cable if the optical ber cable is not connected.
To Next Page
Loading...
