No. SX-DSV02310 - 162 -
R2.0 Motor Business Division, Appliances Company, Panasonic Corporation
8-1-11 RTEX hardware error protection 1/2/3 (Err. 98.1/Err. 98.2/Err. 98.3)
T
his alarm occurs when an error occurs in RTEX communication circuit.
Cause • An error occurs on RTEX communication circuit.
Detecting timing • On power up of servo driver control power.
• Upon restarting by the reset command.
Internal process upon
detecting error
• RTEX communication cannot be established due to incomplete initialization.
• RTEX communication status is still in INITIAL condition (transition).
Action • Replace the servo driver if the cause is not removed after turning on control
power.
Alarm clear attribute • Cannot be cleared.
Display on COM LED • Lighting in red
To Next Page
Loading...
