No. SX-DSV02310 - 166 -
R2.0 Motor Business Division, Appliances Company, Panasonic Corporation
8-3 Locating disconnection point of network cable
W
ith power supplied to all nodes, check the network status LEDs, “LINK”. If an LED is not lighting, check the network
cable connected to the receiving connector (RX) of the servo driver having the unlit LED.
When checking on/off status of the LED, test the electrical connection regardless of condition and performance of RTEX
communication.
LINK LED
Host
controlle
RX TX RX TX
RX TX
Master
Slave
RTEX
MINAS-A5N
[LINK]
OffLighting in green Lighting in green
The cable connected to RX terminal of servo driver on
which LINK LED is not turned on is broken.
[LINK] [LINK]
To Next Page
Loading...
