Parker Compax3 User Manual

Parker EME
Control via RS232 / RS485 / USB
192-120113 N08 C3I12T11 - December 2010
313
5.7 Remote diagnosis via Modem
In this chapter you can read about:
Structure ........................................................................................................................ 314
Configuration of local modem 1 ..................................................................................... 315
Configuration of remote modem 2 .................................................................................. 315
Recommendations for preparing the modem operation .................................................. 316
As the transmission via modem may be very slow and interference-prone, the
operation of the Compax3 ServoManager via modem connection is on your
own risk!
The function setup mode as well as the ROLL mode of the oscilloscope are
not available for remote diagnosis!
It is not recommended to use the logic analyzer in the Compax3 IEC61131-3
debugger due to the limited bandwidth.
Requirements:
For modem operation, a direct and stable telephone connection is required.
Operation via a company-internal telephone system is not recommended.
Caution!

Parker Compax3 Specifications

General

Protection Class	IP20
Control Modes	Torque, Speed, Position
Feedback Options	Incremental encoder, Absolute encoder, Resolver
Communication Interfaces	CANopen, EtherCAT, Profinet
Safety Features	STO (Safe Torque Off), SS1 (Safe Stop 1), SOS (Safe Operating Stop)
Input Voltage	200-480 VAC
Relative Humidity	5% to 85% (non-condensing)
Shock Resistance	According to EN 60068-2-27
Operating Temperature	0°C to +40°C