Parker EME
Setting up Compax3
192-120113 N08 C3I12T11 - December 2010
Limit and monitoring settings
On the "limit and monitoring settings" wizard page, you can set among others the
current and velocity limits in % of the nominal values. The nominal values are
motor parameters resulting from the motor library or from shifting the reference
point on the "motor reference point" wizard page.
Limit and Monitoring Settings wizard page:
1: Current (Torque) Limit
2: Velocity limit
Asynchronous motors
In this chapter you can read about:
Type specification plate data ......................................................................................... 189
Replacement switching diagram - data for a phase ........................................................ 190
Slip Frequency .............................................................................................................. 190
Saturation behavior ....................................................................................................... 191
Cut-off frequency for the field weakening range ............................................................. 191
Rotor time constant ....................................................................................................... 192
Determination of the commutation settings .................................................................... 192
Asynchronous motors: Extension of the controller structure ........................................... 192
Type specification plate data
On the 2nd. wizard page of the Compax3 MotorManager, the type specification
plate data must be entered.
To Next Page
Loading...
Need help?
General
