Parker Compax3

Compax3 device description
C3I12T11
30
192-120113 N08 C3I12T11 - December 2010
3.3 Connections of Compax3S
In this chapter you can read about:
Compax3S connectors .................................................................................................... 30
Connector and pin assignment C3S................................................................................. 31
Control voltage 24VDC / enable connector X4 C3S ......................................................... 33
Motor / Motor brake (C3S connector X3) ......................................................................... 34
Compax3Sxxx V2 ............................................................................................................ 35
Compax3Sxxx V4 ............................................................................................................ 38
3.3.1. Compax3S connectors
X4
X10
X20
X21
X22
X24
X23
S24
X12
X13
X11
X3
X2
X1
LED3
LED2
LED1
X1
AC Supply
X20
HEDA in (Option)
X2
Ballast / DC power voltage
X21
HEDA out (Option)
X3
Motor / Brake
X22
Inputs Outputs (Option M10/12)
X4
24VDC / Enable
X23/
X24
Bus (Option) Connector type
depends on the bus
system!
X10
RS232/RS485
S24
bus settings
X11
Analog/Encoder
LED1
Device status LEDs
X12
Inputs/Outputs
LED2
HEDA LEDs
X13
Motor position feedback
LED3
Bus LEDs
Caution - Risk of Electric Shock!
Always switch devices off before wiring them!
Dangerous voltages are still present until 10 min. after switching off the power
supply.