Parker EME
Setting up Compax3
192-120113 N08 C3I12T11 - December 2010
4.4 Optimization
In this chapter you can read about:
Optimization window ...................................................................................................... 164
Scope ............................................................................................................................ 165
Controller optimization ................................................................................................... 173
Signal filtering with external command value ................................................................. 238
Input simulation ............................................................................................................. 240
Setup mode ................................................................................................................... 242
Load identification .......................................................................................................... 244
Alignment of the analog inputs ....................................................................................... 247
C3 ServoSignalAnalyzer ................................................................................................ 249
ProfileViewer for the optimization of the motion profile ................................................... 285
Turning the motor holding brake on and off .................................................................... 287
Select the entry "Optimization" in the tree.
Open the optimization window by clicking on the "Optimization Tool" button.
To Next Page
Loading...
