Pentair INTELLITOUCH - Page 50

IntelliTouch
®
Control System User’s Guide
40
Assigning a function and freeze protection to a circuit (Continued)
To assign a function to an auxiliary circuit and to add circuit freeze protection:
1. Press the top right side button next to the displayed circuit names (i.e., CLEANER). The circuit
displayed is selected from the previous screen.
2. Use the left and right side button next to PREV and NEXT to select the function for this circuit. For
example, circuit function MASTER CLEANER selects the type of logic needed for a cleaner circuit.
To assign a light function, select IntelliBrite, SAM Light or SAL Light. For the complete list of circuit
functions, see Special Functions for Circuits, on page 41.
Note:When using “pressure cleaners” assign
the circuit to “Master Cleaner.”
3. Use the left and right side button next to ON WITH FREEZE to select YES for freeze protection.
This will activate the circuit if the air temperature drops below 36° F (2° C). Select NO for no freeze
protection. Note:Freeze protection is automatically enabled for SPA, POOL, HI-TEMP, and LOW-
TEMP circuits.
4. Press the SAVEbutton when nished.
5. Press the BACKbutton to return to the Circuits screen and repeat steps 1 through 4 to assign functions
to other circuits.
6. Press EXITbutton to return to the Main screen.
MENU/SETUP/ADV/FUNC/CLEANER
Note: Spa operation and freeze protect
time: Using the “Spa Freeze Override”
feature, the freeze protect default time of 30
minutes can be increase from 30 minutes to
240 minutes maximum. For more information,