Pentair INTELLITOUCH - Selecting Intellibrite Modes; Modes Screen; Modes: Color Light Shows; Feature: Swim

IntelliTouch
®
Control System User’s Guide
48
Setting up IntelliBrite LED lights (Continued)
Selecting IntelliBrite Modes
From the “Modes” screen you can select various preset show color lighting effects, such as “American
mode” and “Sunset mode,” and Sam Style (an emulation of the SAm color scheme). Using the “Hold”
and “Recall” feature (see page 49) you can also capture and save a unique color effect to recall at a later
time.
Modes screen
To access the IntelliBrite “Modes” features from the Lights screen, press the Lights button on the
bottom of the screen, then press the left side button next to “MODES.”
Modes: Color light shows
There are six pre-programmed color light shows available to enhance your backyard pool environment.
Note: If the light was not previously on, after pressing a color show mode button, no illumination
will occur for up to ten (10) seconds (depending on the selection), then a white light will momentarily
illuminate, followed by the color show mode selection. If the light was previously on, pressing the a
color show mode button will momentarily illuminate the previously selected color before changing to the
selected color show.
• SAmmode:Emulates SAm lights color scheme
• Partymode:Rapid color changing building the energy and excitement
• Romancemode: Slow color transitions creating a mesmerizing and calming effect
• Caribbean:Transitions between a variety of blues and greens
• AmericanMode: Patriotic red, white and blue transition
• SunsetMode: Dramatic transitions of orange, red and magenta tones
• RoyaltyMode:Richer, deeper, color tones
Feature: Swim
The “Swim” SAm Style feature cycles through white, magenta, blue and green colors. This feature
emulates the “Color Swim” feature (see page 42). 
Note: If the light was not previously on, after pressing the SWIM button, no illumination will occur
for approximately six (6) seconds followed by the “COLOR SWIM” feature selection. If the light was
previously on, after pressing the SWIM button, the previously selected color will momentarily illuminate,
no illumination will occur for approximately six (6) seconds followed by the “COLOR SWIM” feature
selection.
WARNING - During the off/on switching
process, before the selected color is
displayed, no illumination will occur.
This operating mode is normal during
the switching process. During this
period the pool and spa will be dark
and precautions should be taken to
avoid unforeseen accidents. Failure
to observe this warning may result in
serious injury or death to pool and spa
Color light
shows
LIGHT/INTELLIBRITE/MODES
BACK EXIT
ROMANCE MODE SUNSET MODE
HOLD INTELLIBRITE RECALL
SWIM SAM STYLE COLOR SET
PARTY MODE AMERICAN MODE
CARIBBEAN ROYAL MODE
Color light
shows
Hold
Swim
Recall
Color Set