IntelliTouch
®
Control System User’s Guide
82
Setting up the Remote Control Telephone Feature
The remote control telephone feature allows you to switch on a feature by calling the Indoor Control
Panel via the telephone.
You can only use this feature the TELSPA needs to be connected to the Personality board COM port,
and the phone line.
The following describes how to switch on your spa remotely. You can also scroll through the list of
available features and set any one of them. This feature can also be used by a macro circuit (see page
80).
To setup the telephone remote control:
Go to the
SpaRFandPhoneRemotes screen.
1. Press the button next to CONFIGUREMOD-PHONE to access the Phone Remote setup screen.
2. Press the top left button next to NONE.
3. Press the Up or Down buttons to scroll through the available circuit names until you nd the function
you would like to assign to the telephone remote. Choose the function you will use most often,
for example SPA allows you to call the system and switch on spa ltration and heating with one
command.
Note:If you are using the remote to turn on your spa, you must also enable “MANUAL
HEAT.” This allows the heater to always switch on whenever the spa is switched on via the
telephone. For more information, see page 77.
4. Press the Savebutton to save the setting and return to the remotes screen.
To Next Page
Loading...
Need help?
General
