Pentair INTELLITOUCH - Page 61

IntelliTouch
®
Control System User’s Guide
51
To display the assigned MagicStream circuit on the Lights screen:
5. From the main screen, press the Lightsbuttonon the
bottom of the screen.
6. Press the right side button next to “CONFIGURE” to
assign the previously assigned MagicStream laminar
circuits to the “Lights” screen. Note: The screen on
right shows IntelliBrite light circuits already displayed
on the “Lights” screen. The MagicStream circuits are
not displayed until assigned to the “Lights” screen.
7. Press the button next to “NONE” to assign a laminar
light circuit to the selected button.
8. Press the topleftorrightside button to scroll
through the assigned light circuits. Select the
previously assigned MagicStream circuit name (i.e.
Pool Laminar 1) or AUX circuit. Repeat this step for
other laminar circuits (i.e. Pool Laminar 1).
If there are no circuits available for selection, refer
to “Assigning Circuit Names, ” on page 35, and
“Assigning Circuit Functions and Freeze Protection”
on page 39 for more information.
9. Press the SAVE button on the bottom of the screen.
Press the BACK button to return to the main screen.
The MagicStream laminar circuit will be displayed
on the “Lights” screen, as shown below.
To activate the MagicStream features, see the next page.
LIGHTS
ALL OFF
SYNC
SAVE ALL ON
CONFIGURE
POOL LIGHT
NEXT GROUP
INTELLIBRITE MAGICSTREAM
SPA LIGHT
LIGHTS/CONFIG/POOL LAMINAR 1
PREV
NEXT
PREV
PREV
PREV
NEXT
NEXT
NEXT
POOL LAMINAR 1
NOT APPLICABLE
SAVE EXIT
NOT APPLICABLE
NOT APPLICABLE
MagicStream circuit
buttons
Lights screen using IntelliBrite lights
and MagicStream laminars
IntelliBrite
button for
Color and
Mode Light
show
LIGHTS
ALL OFF
SYNC
SAVE ALL ON
CONFIGURE
POOL LIGHT
NEXT GROUP
INTELLIBRITE MAGICSTREAM
SPA LIGHT
POOL LAMINAR 1
POOL LAMINAR 2