THE NEW PIPER AIRCRAFT, INC.
PA-32-301FT / 301XTC
MAINTENANCE MANUAL
PAGE 3
Jun 1/03
1H13
11-30-00
Meyercord Decals
Decals installed on the instrument panel are Meyercord type manufacturered by Mark-It, 1055
Paramount Tarkway, Batavia. IL 60510. The following procedures should be followed in the event one or
more of these decals must be replaced.
A. Removal
CAUTION: DO NOT USE LACQUER THINNER ON ANY PANEL THAT HAS BEEN PAINTED
WITH ENAMEL OR LACQUER. INSTRUMENT PANELS ARE PAINTED AT THE
FACTORY WITH POLYURETHANE PAINTS.
Remove placard to be replaced with of clean cloth
dampened
with lacquer thinner.
CAUTION: MARK-IT J-70 SOLVENT WILL REMOVE ENAMEL, LACQUER, AND
POLYUTHERANE BASED PAINT PRODUCTS IF LIQUID IS DROPPED ONTO
PAINTED SURFACE AND NOT REMOVED IMMEDIATELY.
If panel is painted with enamel or lacquer use a clean cloth
dampened
with Mark-It J-70 solvent to
remove placard to be replaced.
B. Installation
(1) Mix a solution consisting of 2 parts water and 1 part J-70 solvent (P/N 179-497).
(2) Prepare surface to receive decal by wiping it with a clean cloth
dampened
with the diluted
Mark-It J-70 solvent mixed above.
(3) Submerge decal in the mixed J-70 solution for approximately 3 to 5 seconds.
(4) Remove decal from mixed solution and lay in position.
(5) Using a rubber squeegee, squeegee out from center to edges to remove excess solution.
(6) Wait approximately 1 to 1 1/2 minutes, then remove backing paper.
(7) Using a damp sponge, remove excess solution from face of decal and surrounding area.
To Next Page
Loading...
Need help?
General