6. Scheduled Maintenance - PA-32-301XTC Piper 6XT (S/N’s 3255001 & up) (continued)
THE NEW PIPER AIRCRAFT, INC.
PA-32-301FT / 301XTC
MAINTENANCE MANUAL
PAGE 20
Feb 19/04
1D14
5-20-00
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
D. CABIN AND COCKPIT GROUP (CONT.)
6. Inspect trim operation............................................................................................ O
7. Inspect rudder pedals............................................................................................ O
8. Inspect parking brake valve and brake handle for operation
and cylinder leaks ................................................................................................. O
9. Inspect control wheels, column, pulleys, cables, turnbuckles, and fittings.
(See Note 11.)....................................................................................................... O
10. Inspect flap lever to control cable attachment bolt for condition and security.
(See Note 11.)....................................................................................................... O
11. Check landing, navigation, strobe, cabin, and instrument lights ........................... O O
12. Inspect instruments, lines, and attachments. ....................................................... O
13. Inspect gyro operated instruments and electric turn and bank.
(Overhaul or replace as required.) ........................................................................ O
14. Replace central air filter......................................................................................... O
15. Clean or replace vacuum regulator filter ............................................................... O
16. Inspect altimeter and ELT for installation/certification
per latest revision of AC43.13-1 and tested/inspected
per FAR’s 91.411 and 91.413, respectively........................................................... O
17. Inspect and test ELT per FAR 91.207. (See Testing ELT, 25-60-00.)..................... O
18. Inspect operation of fuel selector valve. ................................................................ O
19. Inspect fuel valve drain lever cover for security. Verify door opens
and closes freely and prevents operation of lever when closed ............................ O O
20. Inspect condition of heater controls and ducts...................................................... O
21. Inspect condition and operation of air vents.......................................................... O
22. Inspect condition of air conditioning ducts ............................................................ O
23. If installed, remove and clean air conditioning evaporator filter............................. O
E. FUSELAGE AND EMPENNAGE GROUP
1. Remove inspection plates and panels................................................................... O
2. Check forward and rear wing attach bolts and fittings for corrosion.
(Refer to 57-40-00, Figure 1.)................................................................................ O
3. Inspect fwd baggage door, latch, and hinge for damage, operation
and security........................................................................................................... O O
4. Inspect battery, shelf, and cables.
Flush area as required and fill battery per Battery, 24-30-00 ................................ O
5. Inspect electronic installations .............................................................................. O
6. Inspect bulkheads and stringers for damage ........................................................ O
7. Inspect antenna mounts and electric wiring .......................................................... O
8. Inspect air conditioning system for refrigerant leaks. (See Note 9.) ...................... O
9. Inspect refrigerant level in sight gauge of receiver-dehydrator.............................. O O
10. Inspect air conditioner condenser air scoop for condition and rigging.
(See Note 17.)....................................................................................................... O O
11. Inspect fuel lines, valves, and gauges for damage and operation......................... O