THE NEW PIPER AIRCRAFT, INC.
PA-32-301FT / 301XTC
MAINTENANCE MANUAL
PAGE 9
Feb 19/04
1D3
5-20-00
5. Scheduled Maintenance - PA-32-301FT Piper 6X (S/N’s 3232001 & up) (continued)
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
B. ENGINE GROUP (CONT.)
42. Inspect condition and tension of alternator drive belt.
(See Adjusting Alternator Belt Tension, 24-30-00.) ............................................... O O
43. If installed, inspect condition of A/C compressor belt and tension.
(See Adjusting Drive Belt Tension, 21-50-00.)....................................................... O O
44. If installed, check A/C compressor oil level. (See Note 9.).................................... O
45. If installed, inspect A/C compressor clutch security and wiring. (See Note 10.) ... O
46. If installed, inspect A/C compressor mounting for cracks, corrosion,
and security........................................................................................................... O
47. Check fluid in brake reservoir. Fill as required....................................................... O O
48. Inspect and lubricate all controls. (Refer to Lubrication Chart, 12-20-00.)............ O
49. Complete overhaul of engine or replace with factory rebuilt...................
50. Install engine cowl................................................................................................. O O
C. CABIN AND COCKPIT GROUP
1. Inspect cockpit and cabin doors, latches, and hinges, and windows, and
aft baggage compartment door, latch, and hinge for damage, operation,
and security........................................................................................................... O
2. Inspect windows for scratches, crazing, and condition.......................................... O
3. Check window and door seals for deterioration, cracks, and voids....................... O
4. Inspect upholstery for tears................................................................................... O
5. Inspect seats, seat belts, shoulder harnesses, security brackets, and bolts.
(See Seat Belt and Shoulder Harness Inspection, 25-10-00.) .............................. O
6. Inspect trim operation............................................................................................ O
7. Inspect rudder pedals............................................................................................ O
8. Inspect parking brake valve and brake handle for operation
and cylinder leaks ................................................................................................. O
9. Inspect control wheels, column, pulleys, cables, turnbuckles, and fittings.
(See Note 11.)....................................................................................................... O
10. Inspect flap lever to control cable attachment bolt for condition and security.
(See Note 11.)....................................................................................................... O
11. Check landing, navigation, strobe, cabin, and instrument lights ........................... O O
12. Inspect instruments, lines, and attachments. ....................................................... O
13. Inspect gyro operated instruments and electric turn and bank.
(Overhaul or replace as required.) ........................................................................ O
14. Replace central air filter......................................................................................... O
15. Clean or replace vacuum regulator filter ............................................................... O
16. Inspect altimeter and transponder for installation/certification per latest
revision of AC43.13-1 and tested/inspected
per FAR’s 91.411 and 91.413, respectively .......................................................... O
17. Inspect and test ELT per FAR 91.207. (See Testing ELT, 25-60-00.)..................... O
18. Inspect operation of fuel selector valve. ................................................................ O
As req’d by Lycoming
Svc Instr. No. 1009