5. Scheduled Maintenance - PA-32-301FT Piper 6X (S/N’s 3232001 & up) (continued)
THE NEW PIPER AIRCRAFT, INC.
PA-32-301FT / 301XTC
MAINTENANCE MANUAL
PAGE 12
Feb 19/04
1D6
5-20-00
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
E. WING GROUP (CONT.)
9. Inspect flaps for surface damage or irregularities (i.e. - skin cracks, distortion,
dents, corrosion, and excessive paint build up); structural defects (i.e. - loose
or missing rivets); misrigging or structural imbalance; hinge damage, excessive
wear, freedom of movement and proper lubrication; and attachment points
for missing or worn hardware................................................................................ O
10. Inspect condition of flap hinge bolts. Replace as required. ................................... O
11. Lubricate per Lubrication Chart, 12-20-00. ........................................................... O O
12. Inspect wing attachment bolts and brackets. (See Note 13.) ................................ O
13. Inspect fuel tanks and lines for leaks and water. (See Note 14.)........................... O
14. Inspect fuel tanks for minimum octane markings .................................................. O
15. Inspect fuel cell vents............................................................................................ O
16. Inspect all control cables, air ducts, electrical leads, lines, and attaching parts
for security, routing, chafing, deterioration, wear, and correct installation.
(See Note 11.)....................................................................................................... O
17. Install inspection plates and fairings...................................................................... O
F. LANDING GEAR GROUP
1. Check oleo struts for proper extension and evidence of fluid leakage.
See Landing Gear, 12-10-00................................................................................. O O
2. Inspect nose gear steering control and travel ....................................................... O
3. Remove wheel fairings .......................................................................................... O
4. Inspect wheel alignment........................................................................................ O
5. Put airplane on jacks. (Refer to 7-10-00.).............................................................. O
6. Inspect tires for cuts, uneven or excessive wear, and slippage............................. O
7. Remove wheels, clean, inspect, and repack bearings .......................................... O
8. Inspect wheels for cracks, corrosion, and broken bolts......................................... O
9. Check tire pressure ............................................................................................... O O
10. Inspect brake lining and disc for wear ................................................................... O
11. Inspect brake backing plates for cracks ................................................................ O
12. Inspect condition of brake and hydraulic lines....................................................... O
13. Inspect shimmy dampener operation .................................................................... O
14. Inspect gear forks for damage............................................................................... O
15. Inspect oleo struts for fluid leaks and scoring ....................................................... O
16. Inspect gear struts, attachments, torque links, and bolts
for condition and security ...................................................................................... O
17. Inspect torque link bolts and bushings. Rebush as required................................. O
18. Inspect wheel fairings and attachments ................................................................ O
19. Inspect all hydraulic lines, electrical leads, and attaching parts for security,
routing, chafing, deterioration, wear, and correct installation ................................ O
20. Lubricate per Lubrication Chart, 12-20-00 ............................................................ O O
21. Install wheel fairings.............................................................................................. O
22. Remove airplane from jacks.................................................................................. O