THE NEW PIPER AIRCRAFT, INC.
PA-32-301FT / 301XTC
MAINTENANCE MANUAL
PAGE 3
Jun 1/03
3H3
33-40-00
2. Navigation
(P
osition) Lights
Two navigation lights are located in each wing tip in the same assembly as the wing tip strobe light. The
navigation lights are controlled by a single switch and a 10 amp circuit breaker.
3. Anti-Collision Strobe Light
Anti-collision strobe lights are mounted on each wing tip in the same assembly as the navigation lights.
These units are rated to flash at approximately 45 times per minute and are controlled by the STROBE
LT switch through the 10 amp ANTI COLL circuit breaker.
A. Removal
a. Remove screw securing navigation light cover and remove cover.
b. Remove the three screws securing navigation light bracket assembly and pull out.
c. Remove strobe lamp by cutting wires on lamp beneath mounting bracket.
d. Remove defective lamp.
e. Remove and discard plug with cut wires from its electrical socket.
B. Installation
a. Route wires from new lamp down through hole in navigation light bracket.
b. Insert wire terminals in plastic plug supplied with new lamp. Wire according to schematic
diagram located in back of this section. Connect plug to receptacle.
c. Position strobe lamp on navigation light bracket.
d. Secure navigation light assembly and bracket with appropriate screw.
Strobe Power Supply Installation
Figure 3
To Next Page
Loading...
Need help?
General