THE NEW PIPER AIRCRAFT, INC.
PA-32-301FT / 301XTC
MAINTENANCE MANUAL
PAGE 1
Jun 1/03
4H13
61-10-00
PROPELLER ASSEMBLY
This section lists procedures for the removal, cleaning, inspection, repair, and installation of the propeller
assembly. Servicing information may be found in 12-20-00.
1. Removal
A. Insure that the master and magneto switches are off.
B. Move fuel selector to off position.
C. Place the mixture control in idle cut-off.
D. Note position of each component to facilitate reinstallation.
E. Remove the screws from around the spinner assembly and remove spinner.
F. Remove the safety wire from the six propeller mounting nuts on studs and remove studs.
G. Place a drip pan under the propeller to catch oil spillage, then remove the propeller.
2. Cleaning, Inspection, and Repair
A. Check for oil and grease leaks.
B. Clean the spinner, propeller hub interior and exterior, and blades with a non-corrosive
solvent.
C. Inspect the hub parts for cracks.
Typical Nicks and Removal Methods
Figure 1