THE NEW PIPER AIRCRAFT, INC.
PA-32-301FT / 301XTC
MAINTENANCE MANUAL
PAGE 5
Feb 19/04
1E5
5-30-00
3. Per Specific Oper
ation / Oper
ating Environment
A. Operation in High Dust or Industrial Pollution Environment
CA
UTION: DISCONNECT LINES FROM PITOT/STATIC SYSTEM BEFORE CONDUCTING THIS
INSPECTION.
Item Inspection Inspection Interval
 Engine Air Filter. Clean and inspect. Daily.
 Cabin Environmental and Inspect and replace if necessary. 100 Hours.
Instrument Air Filters.
 Pitot/Static system. Check for obstruction. Reverse 100 Hours or
flow to lines. as required.
 Landing Gear Oleos Clean. Before each flight.
Inspect. 100 Hours.
 Landing Gear Wheel Clean, inspect and repack. 50 Hours.
Bearings.
 Windows. Inspect for cracks, erosion, crazing, Daily.
visibility, and cleanliness.
 Structure drain holes. Clean with pipe cleaner. Before each flight.
B. Operation in High Salt or High Humidity Environment
Item Inspection Inspection Interval
 Fuselage, Empennage Remove floor panels and exterior 200 Hours.
and Wings. access plates; inspect for corrosion.
 Landing Gear. Inspect for corrosion and lubrication. 200 Hours.
W
ARNING: ENSURE BOTH MAGNETO SWITCHES ARE OFF (GROUNDED), BEFORE TURNING
PROPELLER. ENGINE MAY START IF BOTH SWITCHES ARE NOT OFF. USE EXTREME
CAUTION WHEN ROTATING PROPELLER BY HAND; PROPELLER MAY KICK BACK.
 Engines with more than Each five days, pull prop through five Each 5 days
50 hours total time. complete revolutions. and
Each 30 days, fly aircraft for 30 minutes each 30 days.
or, ground run until oil temperature is in
the green arc. Avoid excessive ground run.
 Engines with less than Each day, pull prop through five Daily
50 hours total time. complete revolutions. and
Each 30 days, fly aircraft for 30 minutes each 30 days.
or, ground run until oil temperature is in
the green arc. Avoid excessive ground run.
 Instruments and Wiring. Inspect for proper seal of cases and 100 Hours.
corrosion.
 Interior. Inspect upholstery, seat belts, seats and 100 Hours.
rugs for corrosion and integrity.
NO
TE: Do not use metallic tie downs (i.e. - chains, cables, etc.) in high salt or high humidity
environments.
To Next Page
Loading...
Need help?
General