(2) Do not adjust the steering
wheel while driving.
(3) When releasing the lock lever,
make sure the steering wheel
is hold firmly as it may drop
heavily.
Maniverter OWN006START16036
The maniverter has a catalytic converter
and an exhaust manifold.
Use ONLY unleaded petrol.
The catalytic converter of the maniverter
has a device that collects the exhaust
gases and very good in reducing the ex-
haust emission. The catalytic converter
is installed in the exhaust system.
Always keep the engine correctly tuned
to prevent damage to the catalyst.
CAUTION
If the engine is not properly main-
tain, the catalytic converter may be
damaged. If the engine malfunc-
tions because of engine misfire or
other loss of performance, tow the
vehicle to an authorised PROTON
service outlet. The continued opera-
tion of the vehicle with the engine
overheating can damage the catalyt-
ic converter of the maniverter and
the vehicle.
WARNING
(1) Do not operate the vehicle in
areas that have flammable
materials. For example, dry
grass or leaves in contact with
the hot exhaust can cause a
fire.
(2) Do not apply an undercoating
paint to the catalytic converter.
The maniverter will be damaged if the
catalytic converter gets hot quickly. Take
the following precautions to prevent
the ignition of the remaining petrol in
the catalytic converter.
1 - Use ONLY unleaded petrol.
2 - Do not drive with a low level of
fuel. If the fuel supply to the engine
stops, the catalytic converter may
be damaged.
3 - Do not turn off the ignition while
driving.
4 - Do not push the vehicle to start the
engine. If the battery of the vehicle
is weak or flat, use another battery
to jump start the engine.
5 - When the engine is running do not
remove the spark plug.
6 - Do not run the engine long if there
is malfunction.
7 - Do not press the accelerator pedal
hard after switching off the engine
as the remaining fuel in catalytic
converter can causes damage to the
can converter.
8 - Stop the vehicle is there is a reduc-
tion in performance or the engine
malfunction. If the situation does
not allow stopping the vehicle, re-
duce speed until it stop.
Send the vehicle to the nearest au-
thorised PROTON service outlet for
inspection.
9 - If there is an engine malfunction, a
burnt odour may indicate catalyst
overheat. Stop the vehicle, switch
off the engine and let is cool.
When the engine is cool, immedi-
ately send the vehicle to an author-
ised PROTON service outlet for re-
pair and service.
Drive-by-wire and Driver
Safety OWN006START16037
This vehicle has a drive-by-wire system.
This system removes the function of a
mechanical linkage (for example acceler-
ator cable) between the accelerator
pedal and the engine. The engine man-
agement system uses the information
supplied by the parameters of certain
components for example the pedal pos-
ition and throttle actuator to control
the engine speed.
97
Identifier: MANOWN001SAGAMC2DOMASEAN Generated: 27.09.2022 11:44:41 a.m.
To Next Page
Loading...