Child Restraint System
(CRS) Mountings
OWN004SEATS21027
Lower anchorage location
There are two mounting points for the
lower anchorage at the rear seat to at-
tach the child restraint seat with the
ISOFIX mountings.
DOIRW004R14015
Top tether anchorage locations
There are two mounting points at the
rear shelf. Attach each tether strap of
the child restraint seat to each of these
mountings.
DOITW004R16003
WARNING
CRS anchorage only support those
loads set correctly by installed child
restraint seat. Do not use this an-
chorage as normal seat belts or at-
tach other items to the vehicle.
How to install a CRS to the lower
anchorage (ISOFIX mountings) and
the top tether anchorage
Attach your child restraint seat to the
rear seats that have the lower anchor-
age.
When you use the lower anchorage, it
is not necessary to attach the child re-
straint seat with the vehicle seat belts.
DOIQW004R11011
A – CRS connectors
To install
1. Remove any obstructions in or
around the connectors.
2. Make sure you store the vehicle
seat belt.
3. Push the connectors (A) of the child
restraint system into the ISOFIX
mounting (B). Follow the supplied
instructions that comes with the
child restraint system.
DOIRW004R14016
A– Connector
51
Identifier: MANOWN001SAGAMC2DOMASEAN Generated: 27.09.2022 11:44:41 a.m.
To Next Page
Loading...