UM-PRORUNNER_Mk5-1.2-EN-US 37
Description
4.3.5 Machine use specifications
If Qimarox does not supply the product conveyors, the specifications below apply to the
product conveyors.
/i
Refer to the machine layout drawing for the correct specifications.
The minimum distance of the product and/or
carrier on the product carrier and parts of
conveyors, conveyor supports, signalling
devices, etc., must be 100 mm.
4.3.6 Specifications of the surrounding area
The surrounding area of the machine must have the following properties:
/i
When the specifications for the surrounding area still deviate from the table above, the
machine must be adjusted to this. Such adjustments shall always be carried out by
Qimarox or after permission from Qimarox.
4.3.7 Electrical specifications
See the type plate. Refer to section 2.1 and the electrical circuit diagrams in chapter 17.
Specifications Value
Maximum weight of infeed conveyor 75 kg
Maximum weight of outfeed conveyor 75 kg
Property Description
General Covered and normally clean for operation. There must be suffi-
cient space around the machine for carrying out maintenance
and other activities on the machine.
Level The maximum allowed height level of the machine position is
1000 m above sea level. At higher elevations the power of the
machine must be adapted according to the SEW manual.
Relative air humidity Maximum 80%.
Temperature Between +5°C (41 F) and 40°C (104 F).
Floor Level. The floor load is provided on the machine specification
sheet.
Required height Refer to the machine layout drawing.
To Next Page
Loading...
Need help?
General