UM-PRORUNNER_Mk5-1.2-EN-US 63
Maintenance vertical conveyor
7.3 Cleaning
1. Switch off the machine.
2. Secure the main power supply switch with a padlock.
3. Remove deposit and dirt by hand.
4. Report any damage to the technically responsible person or to Qimarox and make
sure that any damage is remedied before restarting the machine.
7.4 Lubrication
7.4.1 Lubricate the chain
1. Lubricate the chain with an appropriate chain lubricating agent. Qimarox recommends
the following product: No-Tox Chain Lube.
7.4.2 Lubricate the wheels of the trolley
1. Lubricate the running surfaces of the wheels with Bel-Ray No-Tox HD Grease (62270,
62280) or equivalent.
7.4.3 Lubricate the wheels of the guide
1. Lubricate the running surfaces of the wheels with Bel-Ray No-Tox HD Grease (62270,
62280) or equivalent.
7.5 Check the slack on the sprocket wheels and slide bearings
1. Replace the slide bearings of the tensioning wheel when the diameter is 51 mm or
more. The bronze bearing may maximally wear out 1.0 mm.
7.6 Check the slack on the bearings of the trolleys and guide
1. Replace the bearings of the trolley when the diameter is 30.5 mm or more. The plastic
bearings may maximally wear out 0.5 mm.
DANGER
Do not use any corrosive and inflammable solvents or cleaning agents on the
machine that contain TRI, PER, TETRA or FCHC. Read the instructions on the
packaging when use is made of chemical substances (cleaning agents).
WARNING
• Electrical components should not make contact with water or other liquids.
• Do not clean the machine with compressed air or water under high pres-
sure.
• Avoid parts made of rubber or plastic, such as cables and gaskets, from
making contact with oil, solvents or other chemicals.
To Next Page
Loading...
Need help?
General