UM-PRORUNNER_Mk5-1.2-EN-US 85
Maintenance RollerDrive conveyor
8 Maintenance RollerDrive conveyor
8.1 Specific safety regulations
For optimum functioning of the machine the various machine parts must be regularly
maintained. In this way defects and inaccuracies of the machine are prevented.
WARNING
• The maintenance as described in this chapter is based on 2000 running
hours per year. Adjust the maintenance frequency to the actual number of
running hours per year.
• If required, Qimarox can carry out the maintenance activities.
DANGER
• Only a qualified maintenance engineer is allowed to carry out mainte-
nance activities on the machine. Refer to section 3.2.
• Switch the machine off using the main power supply switch before
starting any maintenance or repair activities. Secure the main power
supply switch with a padlock.
• Do not use any corrosive and inflammable solvents or cleaning
agents on the machine that contain TRI, PER, TETRA or FCHC. Read
the instructions on the packaging when use is made of chemical sub-
stances (cleaning agents).
• After having completed maintenance activities, always put all safety
provisions that have been removed in place again.
• Make sure that the machine has always run empty before carrying
out any activities. No products must be present in the machine.
• Take the appropriate measures for safely working at heights.
WARNING
Avoid parts made of rubber or plastic, such as cables and gaskets, from
making contact with oil, solvents or other chemicals.
To Next Page
Loading...
Need help?
General