Getting started
R&S
®
LCX Series
17User Manual 1179.2260.02 ─ 02
●
Class A equipment is intended for use in industrial environments. It can cause
radio disturbances in residential environments due to possible conducted and radi-
ated disturbances. It is therefore not suitable for class B environments.
If class A equipment causes radio disturbances, take appropriate measures to
eliminate them.
4.1.4 Setting up the R&S LCX
See also:
●
"Setting up the product" on page 10
●
"Intended use" on page 9
4.1.4.1 Placing the R&S LCX on a bench top
To place the product on a bench top
1. Place the product on a stable, flat and level surface. Ensure that the surface can
support the weight of the product. For information on the weight, see the data
sheet.
2.
CAUTION! Foldable feet can collapse. See "Setting up the product" on page 10.
Always fold the feet completely in or out. With folded-out feet, do not place any-
thing on top or underneath the product.
3.
WARNING! A stack of products can fall over and cause injury. Never stack more
than three products on top of each other. Instead, mount them in a rack.
Stack as follows:
● If the products have foldable feet, fold them in completely.
● All products must have the same dimensions (width and length).
● Do not exceed a total load of 50 kg placed on the product at the bottom of the
stack.
Left
= Stacked correctly
Middle left = Stacked incorrectly, too many products
Middle right = Stacked incorrectly, different dimensions
Right = Stacked incorrectly, different dimensions, folded-out feet
4.
NOTICE! Overheating can damage the product.
Prevent overheating as follows:
Preparing for use
To Next Page
Loading...
Need help?
General
