Measurement setups
R&S
®
LCX Series
53User Manual 1179.2260.02 ─ 02
The R&S LCX-Z1 test adapter has two contact slots, each to plug in one lead of the
component. To perform short correction, connect the short circuit plate supplied with
the test fixture. For open correction, leave the slots unconnected.
The clamping jaws adapt to the wire diameter automatically.
6.1.2 Kelvin clip lead
The Kelvin clip lead R&S LCX-Z2 test fixture is designed for measuring components
with particular size, shape or terminals.
Figure 6-2: R&S
LCX-Z2 Kelvin clip lead
The test fixture is equipped with two insulated Kelvin clips that hold the wires or termi-
nals of the component. To perform short correction, connect the clips together. For
open correction, leave the clips unconnected.
The cable positioning for R&S LCX-Z2 has impact to measurement results, especially
with higher frequencies.
About test fixtures
To Next Page
Loading...
