R&S LCX Series - System:rwlock; System:setting:default:save; System:time; System:uptime

Remote control commands
R&S
®
LCX Series
221User Manual 1179.2260.02 ─ 02
SYSTem:RWLock
Locks all front panel controls, i.e. manual operation.
To unlock the front panel control, use command SYSTem:LOCal on page 220.
Example: See Example "General instrument settings" on page 212.
Usage: Event
SYSTem:SETTing:DEFault:SAVE [<File path>]
Saves the current instrument settings in a file with defined filename.
To recall an instrument configuration, use command *RCL.
Setting parameters:
<File path>
Example: See Example "General instrument settings" on page 212.
Usage: Setting only
SYSTem:TIME <Hour>, <Minute>, <Second>
Sets or queries the time for the instrument-internal clock.
The R&S LCX indicates the time in the status bar.
Parameters:
<Hour> Range: 0 to 23
<Minute> Range: 0 to 59
<Second> Range: 0 to 59
Example: See Example "General instrument settings" on page 212.
Manual operation: See "Set Time" on page 124
SYSTem:UPTime?
Queries the up time of the operating system.
Example:
See Example "General instrument settings" on page 212.
Usage: Query only
SYSTem subsystem