R&S LCX Series - Page 174

Remote control commands
R&S
®
LCX Series
174User Manual 1179.2260.02 ─ 02
Sets bit 0 in the event status register when all preceding commands have been execu-
ted. This bit can be used to initiate a service request. The query writes a "1" into the
output buffer when all preceding commands have been executed, which is useful for
command synchronization.
*RCL <Number>
Recall
Loads the instrument settings from an intermediate memory identified by the specified
number. The instrument settings can be saved to this memory using the command
*SAV with the associated number.
*RST
Reset
Sets the instrument to a defined default status. The default settings are indicated in the
description of commands.
Usage:
Setting only
*SAV <Number>
Save
Stores the current instrument settings under the specified number in an intermediate
memory. The settings can be recalled using the command *RCL with the associated
number.
*SRE <Contents>
Service requests enable
Sets the service request enable register to the indicated value. This command deter-
mines under which conditions a service request is triggered.
The query *SRE? returns a decimal value of the service request enable register which
corresponds to the binary-weighted sum of all bits.
Parameters:
<Contents> Contents of the service request enable register in decimal form.
Bit 6 (MSS mask bit) is always 0.
Range: 0 to 255
*STB?
Status byte query
Reads the contents of the status byte in decimal form.
Usage:
Query only
Common commands