R&S LCX Series - Measurement Control Functions

Instrument functions
R&S
®
LCX Series
72User Manual 1179.2260.02 ─ 02
"Voltage Level"
Sets the signal voltage.
"Current Level"
Sets the signal current.
Remote command:
VOLTage[:LEVel] on page 177
CURRent[:LEVel] on page 177
Range: / [Range]
Selects the measurement range.
Remote command:
FUNCtion:IMPedance:RANGe:AUTO on page 196
FUNCtion:IMPedance:RANGe[:VALue] on page 196
Current Bias: / [Bias Level]
Sets the internal the current preload.
Remote command:
BIAS:CURRent[:LEVel] on page 178
Voltage Bias: / [Bias Level]
Sets the value of the internal voltage preload.
Remote command:
BIAS:VOLTage[:LEVel] on page 179
[Comp.]
Accesses the "Open/Short/Load Correction" dialog, see Chapter 8.6.1, "Measurement
parameter settings", on page 75.
[Bias Enable]
Activates the internal voltage or current bias.
Remote command:
BIAS:STATe on page 179
8.5 Measurement control functions
With the measurement control hardkeys at the front panel, you can control a running
measurement.
Access:
► Press the corresponding key ([Auto], [Hold] or [Trig.]) at the front panel.
Repeated pressing a key turns the function on and off (toggle).
The required remote commands are described in Chapter 11.10, "FUNCtion subsys-
tem", on page 194.
Measurement control functions