R&S LCX Series - Measure:trigger:delay; Measure:voltage; Read; Read:impedance

Remote control commands
R&S
®
LCX Series
208User Manual 1179.2260.02 ─ 02
MEASure:TRIGger:DELay <Trigger Delay>
Sets a delay time that elapses after a trigger event before the measurement starts.
Parameters:
<Trigger Delay> Range: 0 s to 60 s
*RST: 0 s
Default unit: s
Example: See Example "Using the MEASure commands" on page 205.
Manual operation: See "Trigger Delay" on page 77
MEASure:VOLTage?
Queries the voltage value following next in the measurement.
Example:
See Example "Using the MEASure commands" on page 205.
Usage: Query only
READ?
Queries the measurement results for measurement pair 2.
Example:
See Example "Acquiring measurement readings" on page 206.
Usage: Query only
READ:IMPedance?
Queries the impedance measurement results.
Example:
See Example "Acquiring measurement readings" on page 206.
Usage: Query only
11.14 STATus subsystem
This system contains the commands for the status reporting system, see Chap-
ter 10.2.4, "Status reporting system", on page 146. *RST has no effect on the status
registers.
11.14.1 Status operation register
This system contains the commands for controlling the STATus:OPERation register
of the status reporting system.
STATus subsystem