R&S LCX Series - Display Subsystem

Remote control commands
R&S
®
LCX Series
192User Manual 1179.2260.02 ─ 02
Parameters:
<Sweep start value> numeric
Example: See Example "Using the DIMeasure function" on page 189.
Options: Option: R&S LCX-K106
Manual operation: See "Minimum" on page 100
DIMeasure:SWEep:PARameter <Sweep parameter>
DIMeasure:SWEep:PARameter? <Sweep parameter>
Selects the measurement parameter that varies in defined steps within the sweep
range (DIMeasure:SWEep:MINimum.
Parameters for setting and query:
<Sweep parameter> VOLTage | FREQuency | VBIas | IBIas
VOLTage
Sweeps the test signal voltage.
FREQuency
Sweeps the test signal frequency.
VBIas
Sweeps the voltage bias.
IBIas
Sweeps the current bias.
Example: See Example "Using the DIMeasure function" on page 189.
Options: Option: R&S LCX-K106
Manual operation: See "Sweep Parameter" on page 100
11.9 DISPLay subsystem
The DISPlay subsystem contains the commands for customizing the display appear-
ance, and enables you to close messages.
DISPLay subsystem